Water well and pump service in Central Florida covers the installation, repair, and replacement of submersible pumps, jet pumps, pressure tanks, pressure switches, and drop pipe components for residential drilled wells. Quality Filters and Pumps holds Florida Water Well Contractor License #7494 and serves Orange, Marion, Lake, Polk, Pasco, Hernando, Citrus, and surrounding counties, led by owner Chase Norris with over 15 years of experience in the region. When a well pump fails, the result is no water at every tap. We diagnose problems above ground first: pressure gauge readings, pressure switch inspection, and pressure tank tap testing tell us whether the failure is in the above ground system or requires a pump pull. Most service calls in Central Florida finish in a single visit. We carry common submersible pump sizes, pressure tanks, and control components on the truck.
How a Residential Well and Pump System Works
A drilled residential well taps into one of Florida's two main aquifer systems: the shallow surficial aquifer (typically 30 to 80 feet deep) or the deep Floridan Aquifer (generally 100 to 400 feet in Central Florida). A submersible pump sits near the bottom of the well casing and pushes water up the drop pipe to the surface. From there, water enters a pressure tank that stores a reserve under air pressure so the pump does not have to run every time you open a faucet.
A pressure switch monitors tank pressure and signals the pump to turn on when pressure drops to the cut-in setting (typically 30 or 40 PSI) and turn off at the cut-out setting (typically 50 or 60 PSI). The pressure tank, pressure switch, check valve, and drop pipe are all components we service and replace without pulling the pump. When the pump motor itself has failed, a full pump pull is required, which is work that the Florida Department of Health requires to be performed by a licensed well contractor under Florida's private well regulations (Florida Department of Health).
Signs Your Well Pump Needs Service
Catching a failing pump early avoids a no-water emergency. Common warning signs include:
- Sudden drop in water pressure: faucets and showers have less flow than usual. This can indicate a failing pump, a partially closed pressure switch, or a waterlogged pressure tank.
- Pump runs constantly: the pump never turns off, or runs far longer than usual to build pressure. A stuck check valve, a failed bladder in the pressure tank, or a pump that is losing capacity are the usual causes.
- Short cycling: the pump turns on and off rapidly in short bursts rather than running through a normal fill cycle. Almost always a pressure tank problem.
- Sputtering or air in the water: air bursts from faucets or the water sputters when first turned on. Can indicate a failing pump, a drop in the water table, or a cracked drop pipe pulling air.
- Unexpectedly high electric bills: a pump running longer than normal consumes more electricity. If your bill jumped and your water usage has not changed, check the pump.
- Discolored or gritty water: sediment in the water after years of clean supply can mean the pump screen is failing or the well is developing a sand problem.
If you notice any of these signs, call us before the pump fails completely. A diagnostic service call is far less disruptive than an emergency no-water situation. For a detailed self-diagnostic walkthrough, see our well pump troubleshooting guide.
Pump Repair vs. Pump Replacement
The right choice depends on which component failed and how old the pump is. Our general framework:
- Always repair, regardless of pump age: pressure switch, pressure tank (bladder or pre-charge failure), above-ground check valve, capacitor, and start relay. These components fail independently of motor life.
- Repair if the pump is under 8 years old: check valve at the pump body, drop wire corrosion, minor drop pipe issues. The pump motor still has reasonable service life remaining.
- Replace if the pump motor has failed and the pump is over 10 years old: Central Florida hard water is tough on pump motors. A second failure of a different component within one to two years is common at this age. Replacement is the more cost-effective long-term decision.
We will always give you a straight recommendation. For detailed guidance on how we diagnose pump failures and what each repair type costs, see our pump repair service page and the Central Florida well pump repair guide.
Well Water Quality in Central Florida
Central Florida groundwater varies significantly by county and aquifer depth. Surficial aquifer wells in many areas deliver soft, slightly acidic water. Floridan Aquifer wells, which supply most of the region, often produce hard water with elevated calcium and magnesium, and in some zones moderate sulfide levels that create a rotten egg odor. Iron is common in both aquifer systems.
Untreated hard water and iron accelerate wear on pump components, pressure tank bladders, and household appliances. A water quality test tells you what is in your water and helps us recommend the right treatment system. The Florida Department of Health recommends that private well owners test their water at least once a year (Florida Department of Health private wells guidance).
We offer water testing services and can connect the results directly to a filtration recommendation. See our water filtration services for whole-house treatment options including iron and sulfur removal, water softening, and reverse osmosis.
Our Well and Pump Services
Quality Filters and Pumps handles the full range of residential well and pump work across Central Florida:
- Submersible pump repair and replacement: we pull, diagnose, and replace submersible pumps from all major manufacturers including Franklin Electric, Goulds, Grundfos, and Myers. We carry common sizes on the truck.
- Pressure tank service: bladder replacement, pre-charge adjustment, and full tank replacement for waterlogged or undersized tanks.
- Pressure switch replacement: fast above-ground repair for burned contacts, stuck diaphragms, and corroded terminals.
- Check valve replacement: above-ground inline valves and pump-body check valves (requires pump pull for pump-body locations).
- Drop pipe and drop wire replacement: for corroded or damaged below-ground components.
- New pump installation: sizing and installation of replacement pumps on existing drilled wells, including proper GPM and head matching for well depth and household demand.
- Emergency service: same-day response for dry-tap situations. Contact us for current pricing and availability.
All well entry work is performed under Florida Water Well Contractor License #7494. We provide written quotes before any work begins. Contact us for current pricing on specific repair and replacement services.
Water Filtration for Central Florida Well Homes
A well pump delivers water to your home, but what that water contains is a separate question. Many Central Florida homeowners on well water deal with hard water scale on fixtures, iron staining in toilets and sinks, or sulfide odor from the tap. These problems do not go away on their own, and hard water actively shortens the life of your pump, pressure tank, and home appliances.
We install whole-house water filtration systems designed specifically for Central Florida well water, including:
- Iron and sulfur removal systems
- Water softeners for hard water
- Whole-house sediment filtration
- Reverse osmosis for drinking water
If you are in the Winter Garden or greater Orange County area and looking for a water filtration system paired with well pump service, we serve that market. Learn more on our water filtration service page.
Service Areas: Winter Garden and Throughout Central Florida
We serve residential and commercial well and pump customers across Central Florida, including:
- Orange County: Orlando, Winter Garden, Ocoee, Apopka, Windermere
- Marion County: Ocala, Dunnellon, Belleview
- Lake County: Leesburg, Clermont, Eustis, Mount Dora, Umatilla
- Polk County: Lakeland, Haines City, Davenport
- Pasco, Hernando, Citrus, and Sumter counties
Call (352) 771-2325 to confirm we serve your location. Emergency dispatch is available throughout our service area.
Frequently Asked Questions
What does a well pump service call include?
We start with a systematic above-ground diagnostic: pressure gauge check, pressure switch inspection, pressure tank tap test, and check valve inspection. If the problem is below ground, we quote a pump pull separately. Most above-ground failures resolve in one visit.
How do I know if my well pump is failing?
The most common signs are sudden loss of water pressure, sputtering faucets, a pump that runs constantly without building pressure, a pump that short-cycles on and off rapidly, or unexpectedly high electric bills. Any of these symptoms warrants a service call.
Should I repair or replace my well pump?
Above-ground components like pressure switches, pressure tanks, and check valves are almost always worth repairing regardless of pump age. If the pump motor itself has failed and the pump is over 10 years old, full replacement is usually the better investment. We give you an honest recommendation every time.
Do you service wells in Winter Garden, FL?
Yes. We serve Winter Garden and the surrounding Orange County area, as well as Marion, Lake, Polk, Pasco, Hernando, Citrus, and other Central Florida counties. Call (352) 771-2325 to confirm availability in your area.
How long does a submersible pump last in Central Florida?
In typical Central Florida water conditions, a properly sized submersible pump lasts 10 to 15 years. Hard water with high mineral content and low pH can shorten service life. Regular pressure tank maintenance and proper sizing extend pump life significantly.
Can you also install a water filtration system for my well?
Yes. We offer complete well water filtration systems for Central Florida homes, including whole-house filters, iron and sulfur removal, water softeners, and reverse osmosis. A water quality test helps us design the right system for your well.